The Boltzmann equation per unit entropy
Dividing by the entropy density removes the dilution by expansion. Only annihilation and its inverse change the count.
How much dark matter is left after the early universe cools? The amount left is set when annihilation can no longer keep up with expansion. Particles that annihilate weakly fall out of balance early and leave many survivors, while strong annihilation leaves few. Particles too feeble to ever reach balance are instead made slowly from the hot bath, and that freeze-in yield grows with the coupling.
Watch dark particles annihilate and appear in a cooling bath. Drag the reaction rate against the expansion rate and see when the count stops changing, whether the particles start in equilibrium or from nothing.
Offline teaching model; the gold line is the Planck 2018 measurement
BackgroundIn the first fraction of a second the universe was a hot soup of particles. If dark matter particles touched that soup, they were made and destroyed in pairs. As the universe expanded and cooled, those reactions slowed down.
Why it mattersThe number left over after the reactions stop is the dark matter we see today. The same equation gives very different answers depending on how strongly the particles interact and whether they started in balance.
Dividing by the entropy density removes the dilution by expansion. Only annihilation and its inverse change the count.
A constant while the particles are relativistic, then a Boltzmann suppression once the bath is too cold to make them.
While this ratio is large the count tracks equilibrium. Freeze-out happens near where it falls through one. The extra factor in the expansion rate is the faster-expansion option.
Freeze-out leaves an amount inversely proportional to the cross-section. Freeze-in from nothing makes an amount proportional to it; the second result holds for this Lab’s contact interaction.
Typical misconceptionAll annihilation stops at the freeze-out temperature.
Better mental modelThe count leaves equilibrium near here, but it keeps falling until reaches a few hundred. The readout for when the count settles shows how long the tail lasts.
Typical misconceptionA stronger interaction always makes more dark matter.
Better mental modelFor particles in balance, stronger annihilation destroys more and leaves less. Only below the hot-relic plateau, where particles never reached balance, does a stronger coupling make more.
Typical misconceptionStarting from nothing must always give less dark matter than starting in balance.
Better mental modelWhen the reaction rate is large, particles made from nothing reach equilibrium quickly and then freeze out exactly as before. The start only matters below the plateau.
Keep the default and watch the cyan reaction bar fall past the orange expansion bar.
What to observe: The violet dots first vanish in flashes, then stop vanishing once the reaction loses the race. The final density is the observed 0.120.Drag the cyan handle up by two decades, or choose Stronger annihilation.
What to observe: Equilibrium lasts longer and the survivors drop more than eightyfold.Choose Freeze-in from nothing, then switch the start back to equilibrium.
What to observe: From nothing, a feeble coupling slowly makes just the observed amount. Starting in balance with the same coupling leaves a hot relic a billion times too dense.Choose Faster expansion: relentless annihilation.
What to observe: The particles leave equilibrium earlier, yet the count keeps falling until the extra fluid fades near 20 MeV. The same cross-section now leaves about 34 times more.You are hereDark Matter Relics: Freeze-Out, Freeze-In and Thermal Decoupling
How dark matter was left over · Reading path
Articles on this path that use this experiment, followed by the other experiments they suggest.