Skip to main content
Sandbox Physics
Fast radio bursts and the cosmic baryon census

How do fast radio bursts count the ordinary matter between galaxies?

Sandbox Physics ·

A fast radio burst is a flash of radio waves that lasts about a millisecond. On its way to us it passes through thin ionised gas, and every free electron in that gas holds back the low frequencies a little more than the high ones. Astronomers measure that delay, turn it into the number of electrons along the path, and compare the number with the distance to the galaxy the burst came from. In 2020 five bursts with known distances carried enough electrons to account for the ordinary matter that surveys of stars and glowing gas had failed to find. Macquart et al., 2020, main text

The ordinary matter nobody could see

Ordinary matter is the stuff made of protons, neutrons and electrons. Astronomers call it baryonic matter. The early universe fixes how much of it there is. The cosmic microwave background and the deuterium and helium made in the first minutes both say that ordinary matter makes up about 5 percent of the total density of the universe.

At redshifts below about 2, adding up stars, cold gas and the hot gas seen in X-rays around groups and clusters accounts for only about half of that. The rest was thought to lie between galaxies, in gas too thin to shine and too hot to absorb much light. This shortfall became known as the missing-baryon problem. Petroff et al., 2022, Section 4.1

How a delay becomes a count

A radio pulse that crosses plasma arrives later at low frequency than at high frequency. The extra delay grows as the inverse square of the frequency, and it is proportional to one number: how many free electrons lie in a thin tube along the path. Radio astronomers call that number the dispersion measure, written DM and quoted in pc cm−3\mathrm{pc\,cm^{-3}}, a parsec of path times electrons per cubic centimetre.

The delay is large enough to measure easily. FRB 180924 has a dispersion measure of 361 pc cm−3361\,\mathrm{pc\,cm^{-3}}, so its signal at 1.2 GHz arrived about 0.37 seconds after its signal at 1.5 GHz. Telescopes record the whole sweep and fit it.

Part of the dispersion measure comes from our own Galaxy, and part from the galaxy where the burst went off. In the 2020 analysis the Milky Way was assigned 30 pc cm−330\,\mathrm{pc\,cm^{-3}} for its disc at high latitude and 50 pc cm−350\,\mathrm{pc\,cm^{-3}} for its halo. What is left after removing those pieces and an estimate for the host belongs to the space in between. Macquart et al., 2020, main text

Why the distance has to come from somewhere else

A dispersion measure by itself does not say how far away a burst is. The distance comes from the host galaxy: once a radio array pins a burst down to a fraction of an arcsecond, an optical telescope can find the galaxy and measure its redshift from its spectrum.

With both numbers for each burst, the test is simple. If the baryon density from the early universe is right, and most of it is ionised gas outside galaxies, the cosmic part of the dispersion measure should rise with redshift along one predicted curve. The five well-localised bursts of the 2020 analysis followed that curve. Treating the baryon density as unknown, they measured it to about 30 percent, in agreement with the early-universe value. Macquart et al., 2020, Figs. 2 and 3

Why each burst lands off the line

No two sightlines cross the same structures. Most miss the gas around big galaxies and groups and come in a little below the average. A few pass through a group or a cluster and land far above it. The host galaxy can add a lot as well.

So a single dispersion measure cannot be read as a distance. FRB 190608, at redshift 0.118, has as much dispersion as the average burst from about redshift 0.3, mostly because its host galaxy adds a large share. The spread also carries information: how far the bursts scatter around the average tells how much gas the halos of galaxies hold on to.

What the newer, larger census adds

A 2024 preprint, revised in June 2025 and still awaiting peer review in its arXiv version 2, analysed 69 localised bursts, more than half of them found by the DSA-110 array. Connor et al., 2025, Fig. 2 It puts about 76 percent of all ordinary matter in the gas between halos and about 15 percent in halos. It also finds that every burst beyond redshift 0.1 has a dispersion per unit redshift of at least 800 pc cm−3800\,\mathrm{pc\,cm^{-3}}, the floor a smooth intergalactic medium would produce.

Try it in the Lab

Watch one pulse cross the universe and see its low frequencies fall behind. Then drag the host galaxy up and down and watch the count of electrons change from one sightline to the next. The next chapter, How free electrons delay a radio burst, derives the delay step by step.

Sources

  1. Macquart et al., 2020, main text
  2. Petroff et al., 2022, Section 4.1
  3. Connor et al., 2025, Fig. 2

Keep reading

What this page links to directly

You are hereHow do fast radio bursts count the ordinary matter between galaxies?

Articles

See this series on the content map →

Fast radio bursts and the cosmic baryon census · Reading path

From one delayed pulse to the missing baryons

  1. You are hereHow do fast radio bursts count the ordinary matter between galaxies?
  2. ArticleHow free electrons delay a radio burst
  3. ArticleAdding up electrons across an expanding universe
  4. ArticleWhy every sightline gives a different dispersion
  5. ArticleRecompute the localized-burst baryon census
  6. ArticleReading the FRB baryon census papers
Something broken, confusing, or missing on this page?Tell us
What kind of feedback?

Sent with this page’s address, its Lab ID, the site language and your device type. Please leave out personal details. Feedback is kept for up to 12 months.Privacy policy