How one plane wave delays one pulsar
The response of a pulsar in direction to a wave travelling along with polarisation . The Lab sums 32 such waves in each frequency bin; the colour on the sky is this response summed over all waves.
How do you tell a bad clock from gravitational waves using pulsars spread over the sky? By how the timing errors of pulsar pairs line up across the sky. A bad clock shifts every pulsar the same way, an error in the Solar System model pushes pulsars on opposite sides in opposite directions, and a gravitational-wave background gives the Hellings–Downs pattern: pairs close together agree, pairs about 80 degrees apart disagree and opposite pairs agree a little again.
Drag pulsars across the sky and mix a clock error, a Solar System ephemeris error and a gravitational-wave background. The pair correlations sort them by their angular pattern.
BackgroundMillisecond pulsars tick so steadily that astronomers can predict each pulse arrival to within about a microsecond over many years. What remains after subtracting the best timing model is the residual. A pulsar timing array watches dozens of such pulsars and looks for residual wander that several pulsars share.
Why it mattersA shared wander can come from a clock on Earth, from an error in where we think the Solar System’s centre of mass is, or from gravitational waves passing Earth. All three can have the same spectrum. Only how the wander is shared between pulsars in different directions tells them apart.
The response of a pulsar in direction to a wave travelling along with polarisation . The Lab sums 32 such waves in each frequency bin; the colour on the sky is this response summed over all waves.
Averaging the product of two responses over all wave directions gives this curve for two different pulsars separated by (NANOGrav 15-year paper, eq. 4). It starts at one half, crosses zero near 49 and 122 degrees and bottoms out near 82.5 degrees.
A clock error is the same in every pulsar, so it adds a constant. A random shift of the Solar System barycentre changes each residual by , which correlates pulsars as the cosine of their separation (Tiburzi et al. 2015).
are the Fourier coefficients of pulsar at frequency , and is the total variance per coefficient. A least-squares fit of the three shapes to all pairs gives the bar chart and the three signal-to-noise readouts.
Typical misconceptionIf every pulsar shows the same kind of slow wander, the array has detected gravitational waves.
Better mental modelA clock or ephemeris error can produce the same spectrum. The decisive evidence is the angular pattern between pairs. NANOGrav found a common spectrum with very high confidence but reported the Hellings–Downs pattern as evidence at about three to four sigma, not as a five-sigma detection.
Typical misconceptionWith enough data every pair correlation should land on the Hellings–Downs curve.
Better mental modelThe curve is an average over many waves. For one sky of sources, each pair scatters around it even without noise (Allen 2022). Only averages over many pairs follow the curve, which is why the chart bins pairs and why arrays need many pulsars.
Leave the default running and watch the colours on the sky, then look at the binned dots in the correlation chart.
What to observe: The sky shows patches of early and late arrival several tens of degrees across. The binned pairs start high, dip below zero around 80 degrees and rise again toward 180 degrees.Choose Clock error, then Solar System ephemeris error, and compare the sky and the bar chart with the default.
What to observe: The clock error turns the whole sky one colour at a time; the ephemeris error splits it into two halves. In each case the matching bar grows while the background bar stays near zero.Choose Only eight pulsars, then drag several pulsars close together on the sky.
What to observe: With only 28 pairs the background signal-to-noise falls to about one, and bunching the pulsars removes the large separations the curve needs.The Hellings–Downs curve, the power-law spectrum and the pair estimator follow the NANOGrav 15-year background paper, sections 2 and 3. The plane-wave response follows Jenet and Romano (2014), the single-sky scatter of pairs follows Allen (2022) and the ephemeris dipole follows Tiburzi et al. (2015 preprint). The pulsar positions come from the public NANOGrav 15-year data set; an independent Python sky integral checks the curve.
Study the pulsar-timing course: from one ticking star to a Galaxy-sized detector
You are herePulsar Timing Arrays and the Hellings–Downs Curve
Pulsar timing arrays and the Hellings–Downs curve · Reading path
Articles on this path that use this experiment, followed by the other experiments they suggest.