Skip to main content
Sandbox Physics
Black hole ringdown and the no-hair test

Why does a newly merged black hole ring like a bell?

Sandbox Physics ·

When two black holes merge, the new hole is lopsided for a moment, and it sheds that distortion as gravitational waves that oscillate and fade, much as a struck bell hums and goes quiet. In general relativity the pitch and the fade time of those waves depend only on the hole's mass and spin. Measuring two of the tones therefore tests whether the new object really is the simple black hole the theory predicts.

Open the black hole ringdown Lab

A bell that shakes off its dents

A bell has a few preferred notes. Strike it anywhere and it rings at those notes, each one fading at its own rate, because the metal loses a little energy on every swing. A black hole behaves in a similar way. Right after a merger its horizon is not round, and space around it is still shaking. The disturbance cannot stay: part of it falls into the hole and the rest travels outward as gravitational waves. What a detector records is a wave that wiggles at a steady pitch while its size drops by the same fraction every millisecond. Physicists call this fading signal the ringdown, and its notes quasinormal modes: "normal modes" like a bell's, "quasi" because each one dies away.

Two numbers set the tone

For a bell, the notes depend on its shape, size and metal. For a black hole that has settled down, general relativity leaves only two numbers that matter: its mass and how fast it spins. A heavier hole is bigger, so it rings at a lower pitch and fades more slowly, in exact proportion to its mass. A faster spin raises the pitch and makes the tone last more cycles.

The first black-hole merger seen by LIGO, GW150914 in September 2015, left a hole of about 68 solar masses as measured at the detectors, spinning at about 0.69 of the maximum a black hole can have. From the full signal, the LIGO and Virgo teams predicted that its main tone should sit at 251±8251\pm8 hertz and fade by a factor of ee in 4.0±0.34.0\pm0.3 milliseconds. Abbott et al., Tests of general relativity with GW150914, arXiv:1602.03841v3 That is a low hum, a little below middle C, which lasts barely a single cycle before it has shrunk by two thirds. Our own calculation for 68.5 solar masses and spin 0.69 gives 249 hertz and 4.16 milliseconds.

The first instant is crowded

Each note of a bell comes with overtones, and so does a black hole. The overtones of the main tone have almost the same pitch but die much faster. For the GW150914 hole the first overtone fades in about 1.4 milliseconds, three times faster than the main tone. Near the loudest moment of the signal the overtone can be the stronger of the two, and a few milliseconds later it is gone.

That matters when you try to read the mass and spin back from the data. In 2019 Matthew Giesler and colleagues fitted computer simulations of merging black holes and found that the main tone alone gives the wrong mass and spin unless the fit starts late in the ringdown. Adding overtones fixed this, and let them describe the signal right from its peak. Giesler, Isi, Scheel and Teukolsky, Black hole ringdown: the importance of overtones, arXiv:1903.08284v2 Starting later avoids the overtones but throws away the loudest part of the signal, so the answer comes out much less precise.

Two tones make a test

The idea that a settled black hole is fixed by its mass and spin alone is called the no-hair theorem. Electric charge would be a third number, and this page ignores it. Nothing else about the stars that formed the hole survives. One tone gives a pitch and a fade time, enough to work out a mass and a spin. A second tone gives another pitch and fade time, so the same mass and spin must predict it too. If they do not, either the object is not a Kerr black hole, the spinning black hole of general relativity, or the theory needs changing.

Maximiliano Isi and colleagues applied this to GW150914 in 2019. They fitted the main tone and one overtone from the signal's peak and found the remnant's mass and spin agreed with the full-signal estimate. When they let the overtone's pitch move away from the predicted value, the data preferred a shift of −0.05±0.2-0.05\pm0.2, that is, no shift, to within about 20 percent. Isi, Giesler, Farr, Scheel and Teukolsky, Testing the no-hair theorem with GW150914, arXiv:1905.00869v2

That result is a check at modest precision, and the overtone behind it is still argued over. In a 2022 preprint, Roberto Cotesta and colleagues reanalysed the same data and reported no evidence for an overtone after the peak, with the support for it changing when the start time moved by less than an overtone's lifetime. Cotesta, Carullo, Berti and Cardoso, Analysis of ringdown overtones in GW150914, arXiv:2201.00822v2 Isi and Will Farr answered in another preprint that they could not reproduce those results and that the overtone evidence held up. Isi and Farr, Revisiting the ringdown of GW150914, arXiv:2202.02941v2

What louder signals will settle

A bigger test needs a louder ringdown, where the second tone stands clearly above the detector noise. Every new event with a loud merger adds one more chance to hear two tones from the same black hole and check that they agree. If a single fit ever lands far from the prediction, the first suspects are the noise, the chosen start time and tones left out of the fit. New physics comes into question only when those are ruled out and several events point the same way.

Try it in the Lab

Watch the default scene for ten seconds, then drag the spin dial up and listen with your eyes: the rings get closer together and fade more slowly. Open the black hole ringdown Lab

Sources

  1. Abbott et al., Tests of general relativity with GW150914, arXiv:1602.03841v3
  2. Giesler, Isi, Scheel and Teukolsky, Black hole ringdown: the importance of overtones, arXiv:1903.08284v2
  3. Isi, Giesler, Farr, Scheel and Teukolsky, Testing the no-hair theorem with GW150914, arXiv:1905.00869v2
  4. Cotesta, Carullo, Berti and Cardoso, Analysis of ringdown overtones in GW150914, arXiv:2201.00822v2
  5. Isi and Farr, Revisiting the ringdown of GW150914, arXiv:2202.02941v2

Keep reading

What this page links to directly

You are hereWhy does a newly merged black hole ring like a bell?

Articles

See this series on the content map →

Black hole ringdown and the no-hair test · Reading path

From a ringing black hole to a no-hair test

  1. You are hereWhy does a newly merged black hole ring like a bell?
  2. ArticleDamped tones and the Kerr spectrum
  3. ArticleWhy a ringdown fit needs the overtone near the peak
  4. ArticleFrom two tones to a no-hair test
  5. ArticleRecomputing ringdown tones, a synthetic signal and a slice of GW150914
  6. ArticleHow to read the 2019 GW150914 overtone paper and the debate that followed
Something broken, confusing, or missing on this page?Tell us
What kind of feedback?

Sent with this page’s address, its Lab ID, the site language and your device type. Please leave out personal details. Feedback is kept for up to 12 months.Privacy policy