A sum of damped tones
The Lab fits this model from the start time with one tone () or two (). Amplitudes and phases are free; frequencies and damping times are not.
Why does a ringdown fit near the peak need the overtone? A black hole left by a merger rings at a few set tones, and in general relativity their pitch and fade time depend only on its mass and spin. Two measured tones therefore test that rule, but close to the loudest moment a fast-fading overtone must be included, or the inferred mass and spin come out wrong. A single fit that drifts away from the prediction is not, by itself, new physics.
Drag the remnant mass, spin and fit start. Two damped tones with and pin down the black hole; dropping the overtone biases the result.
Synthetic record computed in this browser; no detector data.
From this start time the fundamental-only fit misses the injected remnant; adding the overtone recovers it.
Horizontal: time after the peak in ms. Vertical: whitened strain in units of the injected fundamental amplitude . Grey samples before are left out of both fits.
Horizontal: over the whole prior. Vertical: . Flat priors; amplitudes and phases fitted.
Horizontal: with , flat prior on . Mass and spin are marginalised.
A credible level near 100 % means the injected values sit outside the inferred region. Over many noise draws the 90 % region should miss about one time in ten.
BackgroundAfter two black holes merge, the remnant settles down by radiating damped gravitational waves. In general relativity each tone, labelled by , has a frequency and a damping time fixed by the remnant mass and spin alone. The overtone has almost the same pitch as the fundamental but dies about three times faster.
Why it mattersMove the fit start and watch whether a model with one tone, or with two, can find the remnant that was put into the record.
The Lab fits this model from the start time with one tone () or two (). Amplitudes and phases are free; frequencies and damping times are not.
The dimensionless number comes from black-hole perturbation theory. The Lab reads it from a table computed with Leaver’s continued-fraction method and checked against the published Berti tables. Doubling halves every frequency.
For each trial the columns of are the damped cosines and sines of the tones. Least squares fixes the amplitudes; is the white-noise level. The outlines enclose 90 % of the resulting weight on a flat grid.
Isi et al. (2019) used this form on GW150914. A value of far from zero, repeated across events and robust to the start time and noise model, would be a problem for general relativity; one wide or offset curve is not.
Typical misconceptionStarting the fit later always gives a cleaner answer, because the overtone has gone.
Better mental modelLater start times avoid the overtone but throw away the loudest part of the signal, so the regions grow. With the default record the fundamental-only region already contains the injected values a couple of M after the peak, mostly because it has grown, not because the bias has gone. By 10 M it is wider than the two-tone region from the peak.
Typical misconceptionIf the fitted overtone frequency is not exactly the Kerr value, general relativity has failed.
Better mental modelNoise alone moves the curve: try other noise draws. A real test also has to rule out a wrong start time, missing modes, nonlinear effects and detector noise that is not white. Published GW150914 analyses disagree on how strongly the overtone is detected at all.
Start from the default and compare the amber dashed outline with the white cross in the mass-spin chart.
What to observe: The fundamental-only fit from the peak points to a lighter, slower-spinning remnant; the two-tone fit around it contains the injected .Drag along the strain chart, or choose “Wait for the fundamental”.
What to observe: By the overtone is already weaker than the fundamental and the amber outline contains the cross, but both regions are much larger than the two-tone region from the peak.Choose “A loud event” and look at the overtone frequency test.
What to observe: At the curve for narrows and still contains zero, while the fundamental-only outline shrinks to a small region well away from the cross.Drag the ergoregion edge and the spin dial in the scene.
What to observe: A heavier remnant rings at a lower pitch with longer waves; a faster spin raises the pitch and makes the fundamental ring longer.You are hereBlack Hole Ringdown and the No-Hair Test
Black hole ringdown and the no-hair test · Reading path
Articles on this path that use this experiment, followed by the other experiments they suggest.