---
title: "Dark Matter Relics: Freeze-Out, Freeze-In and Thermal Decoupling Interactive Lab | Sandbox Physics"
description: "How much dark matter is left after the early universe cools? The amount left is set when annihilation can no longer keep up with expansion."
canonical_url: "https://sandboxphysics.com/labs/dark-matter-freeze-out-freeze-in/"
language: "en"
page_type: "lab"
alternate_languages:
  zh-CN: "https://sandboxphysics.com/zh/labs/dark-matter-freeze-out-freeze-in/"
last_modified: "2026-11-17"
---

# Dark Matter Relics: Freeze-Out, Freeze-In and Thermal Decoupling

**How much dark matter is left after the early universe cools?** The amount left is set when annihilation can no longer keep up with expansion. Particles that annihilate weakly fall out of balance early and leave many survivors, while strong annihilation leaves few. Particles too feeble to ever reach balance are instead made slowly from the hot bath, and that freeze-in yield grows with the coupling.

Watch dark particles annihilate and appear in a cooling bath. Drag the reaction rate against the expansion rate and see when the count stops changing, whether the particles start in equilibrium or from nothing.

> Interactive simulation: open this page in a web browser to change the parameters and run the model.

Model assumptions

This is an offline teaching model, not a fit to data or a particular particle theory. One stable particle of mass $m$ with two internal states pair-annihilates into massless bath particles through a contact interaction with a constant matrix element; its thermally averaged cross-section follows the relativistic average of Gondolo and Gelmini (1991), so it falls as one over temperature squared when the particles are hot and tends to the low-temperature value set by the slider. Maxwell–Boltzmann statistics are used throughout, so the hot-relic plateau is 17 percent below the Bose–Einstein value quoted by the Particle Data Group. The number of relativistic degrees of freedom is held at 86.25 for both energy and entropy; real values fall as the universe cools; with the full count, Steigman, Dasgupta and Beacom (2012) need an 8 percent smaller cross-section for the observed density. The equation for the number per unit entropy is solved with an implicit second-order method from $x=m/T=0.001$; particles either start with the equilibrium number or with none. Faster expansion adds a fluid whose energy density falls as $T^{4+n}$, following D’Eramo, Fernandez and Profumo (2017); the slider sets the temperature where it equals radiation, kept above 20 MeV so nucleosynthesis is safe. With the degrees of freedom fixed, the fluid does not gain the boost that the real drop in their number gives it near 20 MeV, so faster-expansion relics come out 2 to 3 times below Fig. 1 of that paper. Inverse processes use detailed balance; decays, co-annihilation, resonances, Sommerfeld enhancement, kinetic decoupling and entropy release are omitted. The observed density $\Omega h^2=0.120\pm0.001$ comes from Planck 2018. On the stage, dot counts follow the logarithm of the number per unit entropy and are schematic.

## What the equation leaves behind

Offline teaching model; the gold line is the Planck 2018 measurement

### Particles per unit entropy $Y=n/s$

this calculation equilibrium amount that gives the observed density

### Reaction against expansion $\Gamma/H$

equilibrium reaction rate rate for the particles present expansion rate

### Density today for every annihilation strength $\Omega h^2\ \text{vs}\ \langle\sigma v\rangle_0$

start in equilibrium start from nothing Planck 2018 value

## Follow dark particles through the cooling universe

**Background** In the first fraction of a second the universe was a hot soup of particles. If dark matter particles touched that soup, they were made and destroyed in pairs. As the universe expanded and cooled, those reactions slowed down.

**Why it matters** The number left over after the reactions stop is the dark matter we see today. The same equation gives very different answers depending on how strongly the particles interact and whether they started in balance.

- **One-sentence intuition**: The count per unit entropy stops changing once the reaction rate falls below the expansion rate. For particles in balance, stronger annihilation keeps them in balance longer and leaves fewer. For particles never in balance, stronger coupling makes more. The two branches meet at a hot-relic plateau, and a faster early expansion can freeze particles out early but let annihilation keep thinning them.

### Core mathematical model

#### The Boltzmann equation per unit entropy

$$
\frac{dY}{d\ln x}=-\frac{s\langle\sigma v\rangle}{H}\left(Y^2-Y_{\rm eq}^2\right),\qquad Y=\frac{n}{s},\quad x=\frac{m}{T}
$$

Dividing by the entropy density removes the dilution by expansion. Only annihilation and its inverse change the count.

#### The equilibrium count

$$
Y_{\rm eq}=\frac{45\,g}{4\pi^4 g_{*s}}\,x^2K_2(x)\;\to\;\begin{cases}\dfrac{90\,g}{4\pi^4g_{*s}}, & x\ll1\\[1ex]\dfrac{45\,g}{4\pi^4g_{*s}}\sqrt{\dfrac{\pi}{2}}\,x^{3/2}e^{-x}, & x\gg1\end{cases}
$$

A constant while the particles are relativistic, then a Boltzmann suppression once the bath is too cold to make them.

#### The race between reaction and expansion

$$
\frac{\Gamma}{H}=\frac{n_{\rm eq}\langle\sigma v\rangle}{H},\qquad H=\sqrt{\frac{\pi^2 g_*}{90}}\,\frac{T^2}{M_{\rm Pl}}\sqrt{1+\left(\frac{T}{T_r}\right)^n}
$$

While this ratio is large the count tracks equilibrium. Freeze-out happens near where it falls through one. The extra factor in the expansion rate is the faster-expansion option.

#### Two closed-form answers

$$
Y_\infty^{\rm FO}\simeq\frac{x_f}{\lambda},\quad \lambda=\frac{s\,\langle\sigma v\rangle_0}{H}\Big|_{T=m};\qquad Y_\infty^{\rm FI}=\frac{3\pi^2}{32}\left(\frac{45g}{4\pi^4g_{*s}}\right)^2\lambda
$$

Freeze-out leaves an amount inversely proportional to the cross-section. Freeze-in from nothing makes an amount proportional to it; the second result holds for this Lab’s contact interaction.

### Common difficulties

#### Freeze-out is not a sudden stop

**Typical misconception** All annihilation stops at the freeze-out temperature.

**Better mental model** The count leaves equilibrium near $x\approx25$ here, but it keeps falling until $x$ reaches a few hundred. The readout for when the count settles shows how long the tail lasts.

#### Stronger is not always more

**Typical misconception** A stronger interaction always makes more dark matter.

**Better mental model** For particles in balance, stronger annihilation destroys more and leaves less. Only below the hot-relic plateau, where particles never reached balance, does a stronger coupling make more.

#### The starting state can stop mattering

**Typical misconception** Starting from nothing must always give less dark matter than starting in balance.

**Better mental model** When the reaction rate is large, particles made from nothing reach equilibrium quickly and then freeze out exactly as before. The start only matters below the plateau.

### Run the experiment

1. 01

   #### Watch freeze-out

   Keep the default and watch the cyan reaction bar fall past the orange expansion bar.

   **What to observe:** The violet dots first vanish in flashes, then stop vanishing once the reaction loses the race. The final density is the observed 0.120.

2. 02

   #### Drag the reaction stronger

   Drag the cyan handle up by two decades, or choose Stronger annihilation.

   **What to observe:** Equilibrium lasts longer and the survivors drop more than eightyfold.

3. 03

   #### Go below the plateau

   Choose Freeze-in from nothing, then switch the start back to equilibrium.

   **What to observe:** From nothing, a feeble coupling slowly makes just the observed amount. Starting in balance with the same coupling leaves a hot relic a billion times too dense.

4. 04

   #### Speed up the early expansion

   Choose Faster expansion: relentless annihilation.

   **What to observe:** The particles leave equilibrium earlier, yet the count keeps falling until the extra fluid fades near 20 MeV. The same cross-section now leaves about 34 times more.

Physical conclusion

One equation covers three histories: freeze-out, the hot relic and freeze-in. The answer depends on the strength of the reaction, the starting state and how fast the universe expanded before nucleosynthesis.

## Related experiments and articles

How dark matter was left over · Reading path

### From thermal equilibrium to relentless dark matter

Articles on this path that use this experiment, followed by the other experiments they suggest.

1. [Article **Why did any dark matter survive the hot early universe?**](https://sandboxphysics.com/stories/dark-matter-relics/why-some-dark-matter-survived-the-cooling/)
2. [Article **Equilibrium, expansion and the reaction race**](https://sandboxphysics.com/stories/dark-matter-relics/equilibrium-expansion-and-the-reaction-race/)
3. [Article **The Boltzmann equation and freeze-out**](https://sandboxphysics.com/stories/dark-matter-relics/the-boltzmann-equation-and-freeze-out/)
4. [Article **Freeze-in, hot relics and faster expansion**](https://sandboxphysics.com/stories/dark-matter-relics/freeze-in-hot-relics-and-faster-expansion/)
5. [Article **Recompute a relic abundance with the saved scripts**](https://sandboxphysics.com/stories/dark-matter-relics/recompute-a-relic-abundance/)
6. [Article **How to read the relentless dark matter paper of D'Eramo and colleagues**](https://sandboxphysics.com/stories/dark-matter-relics/reading-relentless-dark-matter/)

Fields & matter · Starter path

## From a field to an electron microscope

Map an electric field and steer a charged particle. Then find the electron's wavelength and use electron beams to see a crystal and a surface.

[Start here → **Make an Electric Field Visible** Move the probe around a dipole and check that the field always points downhill on the potential landscape. Observe · 8 min](https://sandboxphysics.com/labs/electric-field/)

1. [1 Make an Electric Field Visible](https://sandboxphysics.com/labs/electric-field/)
2. [2 A Charge Bending through Fields](https://sandboxphysics.com/labs/charged-particle/)
3. [3 Electron Wavelength & Voltage](https://sandboxphysics.com/labs/electron-wavelength/)
4. [4 Electron Diffraction & Reciprocal Space](https://sandboxphysics.com/labs/electron-diffraction/)
5. [5 TEM Bright Field, Dark Field & SAED](https://sandboxphysics.com/labs/tem-mode-selector/)
6. [6 SEM Secondary-Electron Topography](https://sandboxphysics.com/labs/sem-topography/)

[View the full path →](https://sandboxphysics.com/topics/fields-and-matter/#starter-path)
